RFC 9097 §9: Reporting Formats
The 15 Requirements of RFC 9097 §9, each quoted from the RFC with its state and the tests that prove it. Conformance explains the states.
| State | Requirements |
|---|---|
| Tested | 9 |
| Deviation | 6 |
RFC9097-9-1
Tested
The Singleton IP-Layer Capacity results SHOULD be accompanied by the context under which they were measured. * Timestamp (especially the time when the maximum was observed in dtn). * Source and Destination (by IP or other meaningful ID). * Other inner Parameters of the test case (Section 4). * Outer Parameters, such as “test conducted in motion” or other factors belonging to the context of the measurement. * Result validity (indicating cases where the process was somehow interrupted or the attempt failed). * A field where unusual circumstances could be documented, and another one for “ignore / mask out” purposes in further processing.
Proving tests:
crates/udpstp/src/results.rs::a_completed_testcrates/udpstp/src/results.rs::terminal_layout_preserves_measurements_context_and_validitycrates/udpstp/src/test_results.rs::human_context_preserves_private_identities_and_received_times
RFC9097-9-2
Deviation
The Maximum IP-Layer Capacity results SHOULD be reported in tabular format.
Recorded in compact-human-final-metrics.
Proving tests:
crates/udpstp/src/results.rs::a_completed_testcrates/udpstp/src/results.rs::terminal_layout_preserves_measurements_context_and_validity
RFC9097-9-3
Deviation
There SHOULD be a column that identifies the test Phase.
Note: Maximum IP-Layer Capacity table.
Recorded in compact-human-final-metrics.
Conformance Records: results-name-the-phase-and-f.
Proving tests:
crates/udpstp/src/results.rs::a_completed_testcrates/udpstp/src/results.rs::terminal_layout_preserves_measurements_context_and_validity
RFC9097-9-4
Deviation
There SHOULD be a column listing the number of flows used in that Phase.
Recorded in compact-human-final-metrics.
Conformance Records: results-name-the-phase-and-f.
Proving tests:
crates/udpstp/src/results.rs::a_completed_testcrates/udpstp/src/results.rs::terminal_layout_preserves_measurements_context_and_validity
RFC9097-9-5
Deviation
The remaining columns SHOULD report the following results for the aggregate of all flows, including the Maximum IP-Layer Capacity, the Loss Ratio, the RTT minimum, RTT maximum, and other metrics tested having similar relevance.
Recorded in compact-human-final-metrics.
Proving tests:
crates/udpstp/src/results.rs::a_completed_testcrates/udpstp/src/results.rs::terminal_layout_preserves_measurements_context_and_validity
RFC9097-9-6
Tested
As mentioned in Section 6.6, bimodal (or multi-modal) maxima SHALL be reported for each mode separately.
Note: Capacity Modes; restates RFC9097-6.6-3.
Proving tests:
crates/udpstp/src/json.rs::a_bimodal_test_has_obudpst_keys_and_formscrates/udpstp/src/results.rs::a_watchdog_ended_test_with_two_capacity_modescrates/udpstp/src/results.rs::terminal_layout_preserves_measurements_context_and_validitycrates/udpstp-core/src/results.rs::a_split_makes_two_capacity_modes
RFC9097-9-7
Tested
The sub-interval time, dt, MUST accompany a report of Maximum IP- Layer Capacity results, as well as the remaining Parameters from Section 4 (“General Parameters and Definitions”).
Proving tests:
crates/udpstp/src/results.rs::a_completed_testcrates/udpstp/src/results.rs::terminal_layout_preserves_measurements_context_and_validity
RFC9097-9-8
Tested
The PM list metrics corresponding to the sub-interval where the Maximum Capacity occurred MUST accompany a report of Maximum IP-Layer Capacity results, for each test Phase.
Proving tests:
crates/udpstp/src/results.rs::a_completed_testcrates/udpstp/src/results.rs::terminal_layout_preserves_measurements_context_and_validitycrates/udpstp/src/results.rs::maxima_keep_measured_rtt_minimum_without_variation
RFC9097-9-9
Tested
The IP-Layer Sender Bit Rate results SHOULD be reported in tabular format.
Proving tests:
RFC9097-9-10
Tested
There SHOULD be a column that identifies the test Phase.
Note: The table of IP-Layer Sender Bit Rates.
Conformance Records: results-name-the-phase-and-f.
Proving tests:
RFC9097-9-11
Deviation
There SHOULD be a column listing each individual (numbered) flow used in that Phase, or the aggregate of flows in that Phase.
Recorded in sender-bit-rate-per-sub-interval.
RFC9097-9-12
Deviation
A corresponding column SHOULD identify the specific sending rate sub- interval, stn, for each flow and aggregate.
Recorded in sender-bit-rate-per-sub-interval.
RFC9097-9-13
Tested
A final column SHOULD report the IP-Layer Sender Bit Rate results for each flow used, or the aggregate of all flows.
Proving tests:
RFC9097-9-14
Tested
The sub-interval duration, st, MUST accompany a report of Sender IP- Layer Bit Rate results.
Proving tests:
RFC9097-9-15
Tested
Also, the values of the remaining Parameters from Section 4 (“General Parameters and Definitions”) MUST be reported.
Proving tests: